Interface+ Module

Interface module for Mark air heaters

Article code: 0629188

An Interface+ can be used in two ways.

1. Power control: An externally supplied 0-10VDC signal is converted into a power control of the burner. With an Interface+ module, one G(S)+ can be controlled.
Potential free entry: Reset
Potential free exits: Malfunction
Operation

2. Connection BMS (building management system): Settings, actual temperatures and fault codes can be read using Modbus. Settings of the OptiTherm+ can be modified.

Specifications:

Wiring: Shielded bus cable (between Interface+ and air heater)
Dimensions: 109x154x49 mm (lxwxh)
Weight: 498 grams
Degree of protection: IP20
Ambient temperature: 0-40°C

Controls/to be applied for:

GSX gas-fired air heater

Economical heating with the GSX gas-fired air heater With the Mark GSX gas-fired air heater, heat is generated via...

OptiTherm+ digital clock thermostat

Digital clock thermostat with internal room sensor Article code: 0629189 The OptiTherm+ is a digital clock thermostat with internal...

GC+ direct fired heater

Custom made directly fired air heater In addition to the high efficiency air heater, the Mark range also includes a...

GS+ natural gas air heater

Gas-fired high performance natural gas air heater with axial fan Mark manufactures a gas-fired, high-performance natural gas air heater with...